RS 6 V8-4.2L Turbo (BCY) (2003)
/Page-4222002.png)
-
Remove nuts - 4 - (4x).
-
Remove airbag unit.
-
Set down airbag unit with impact cushion facing upward.
Installing
WARNING: Observe the safety precautions for side airbags.
-
Make sure that connector - 6 - engages properly (audible click).
-
Install airbag unit.
-
Switch on ignition.
WARNING: Make sure that nobody is in the vehicle.
See Caution for connecting Telematics battery
-
Connect battery Ground (GND) strap.
2
-
Support
-
Must be replaced if airbag has triggered
-
Remove airbag unit.
-
Remove bolts - 5 - (4x).
-
Remove nuts - 3 - (2x)
