RS 6 V8-4.2L Turbo (BCY) (2003)
Seat Belt Buckle: Testing and Inspection
Belt Buckle, Attachment Point
-
Removing seat.
-
Belt buckle -1-.
-
Unscrew bolt -2-.
Tightening torque: 24 Nm (18 ft lb)
NOTE:
-
Due to control reasons, it is possible that seat occupation recognition and seatbelt fastened sensor have been installed between VIN 4BZV 024500
and 4BZV 033300 that are without function.
-
When replacing a seat belt buckle on vehicles in the above mentioned VIN range, install a belt buckle without a "belt fastened" detector.
On vehicles with a "belt fastened" detector and belt buckle switch (only on driver's side, in models for some countries), remove wires from red connector
housing.
-
Using a screwdriver, pry out retaining hooks -4- on red connector housing -1-.
-
Push red connector housing -1- through toward the rear.
Wire pin -6- (2x) is for "belt fastened" detector.