audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Sensor For Transverse Acceleration -G200- and Sender For Rotation Rate -G202- For Bosch 5.3, Removing and Installing|Page 1361 > < Sensor For Transverse Acceleration -G200- and Sender For Rotation Rate -G202- For Bosch 5.3, Removing and Installing

RS 6 V8-4.2L Turbo (BCY) (2003)

Page 2
background image

Sensor for transverse acceleration -G200- following removal of control module for ultra-sound sensors -J347-.

CAUTION:  
^

Lateral acceleration sensor is sensitive to impact.

^

If the sensor has been dropped by mistake it may not work properly and must not be installed into the vehicle. Do not use the sensor again.

Tightening torque of screws 2 Nm.

Installing 
The remaining installation steps are carried out in reverse sequence:
-

Installing rear seat

-

Repair Manual Body Interior

-

Enter radio code.

Sensor For Transverse Acceleration -G200- and Sender For Rotation Rate -G202- For Bosch 5.3, Removing and Installing|Page 1361 > < Sensor For Transverse Acceleration -G200- and Sender For Rotation Rate -G202- For Bosch 5.3, Removing and Installing