RS 6 V8-4.2L Turbo (BCY) (2003)
-
Remove side panel.
-
Disengage tab on yellow connector - 3 - and disconnect connector.
-
Remove two bolts - 2 - at crash sensor.
-
Installing
-
Switch ignition on.
WARNING: No person may be inside the vehicle when connecting the battery.
-
Connect battery Ground (GND) strap.
2
-
Bolts (2x)
-
Tightening torque 9 Nm
3
-
Acceleration sensor connector
NOTE:
-
Not the measure values after connect the battery.
-
If the light for Airbag Malfunction Indicator Lamp (MIL) -K75- illuminates after assembly. Use the VAS 5051 to check fault memory and
then check it again.