RS 6 V8-4.2L Turbo (BCY) (2003)
Air Bag Control Module: Service and Repair
Through CW 35.99
Airbag Control Module -J234- (through CW 35.99), Removing And Installing
WARNING: Observe all safety precautions before starting work on any part of airbag system.
See Caution before beginning repairs on the electrical system
-
Disconnect battery Ground (GND) strap/cable.
-
Remove front section of center console.
-
Remove connecting pieces for air ducts to rear left and right footwell vents.
-
Release retainer on connector - 2 -.
-
Pull connector - 2 - out of control module - 1 -.
-
Remove nuts - 3 - (3x).
Tightening torque: 6 Nm (53 in.lb)
-
Remove control module.
See Caution for connecting Telematics battery
NOTE: If control module is replaced, it must be coded.
-
After connecting battery, check vehicle equipment (radio, clock, power windows) as per Repair Manual and/or Owner's manual.
-
If the airbag Malfunction Indicator Lamp (MIL) -K75- signals a malfunction after assembling then the DTC memory must be erased and checked
again with VAG 1551 scan tool.