RS 6 V8-4.2L Turbo (BCY) (2003)
-
Replace ATF inspection plug gasket - arrow - .
-
If ATF drips from ATF inspection hole before ATF has reached 40°C, ATF level - arrow - is OK.
Note:
-
The ATF inspection plug must be installed again before ATF reaches a temperature of 45°C (for hot countries 50°C).
-
Add ATF if no ATF has escaped from ATF check plug hole by 40°C .
-
Fasten ATF inspection plug with new gasket to 80 Nm. The ATF check is now completed.
-
Press button to end function "08 - Read measured value block" .
-
Select "06 - End output" .
-
Switch off ignition and disconnect diagnostic connector.
Filling ATF
If no ATF escapes at ATF inspection opening at 40°C, ATF must be topped off;
Note: