S4 V8-4.2L (BHF) (2004)
-
Remove Coolant Fan Control (FC) Control Module -J293- from radiator - arrow -.
CAUTION: Do not open A/C system refrigerant circuit.
Note: Do not bend or stretch lines or hoses as condenser and/or refrigerant lines/hoses may be damaged.
-
Disconnect electrical harness connector - 1 - at High Pressure Sensor -G65-.
-
Remove bolts - arrows -.
-
Remove condenser and swing downward with lines connected.
-
Unlock both radiator retaining bolts and remove by pulling upward - arrows -.
-
Tilt radiator forward at upper edge, pull up and remove.
Installing
Installation is performed in reverse order of removal. Note the following:
-
Install front bumper cover.
-
Fill with coolant.
Note: Complete coolant must be replaced if the radiator was replaced.
Tightening torques