S4 V8-4.2L (BHF) (2004)
^
Bearing shells that are worn through the nickel coating must be replaced.
-
Remove guide frame and clean journals.
-
Place Plastigage over entire width of bearing journal or into bearing shells.
^
Plastigage must rest in center of bearing shell.
-
Install guide frame and tighten to 30 Nm. DO NOT turn crankshaft.
-
Remove guide frame again.
-
Compare width of Plastigage with measuring scale:
^
New radial play: 0.010 to 0.039 mm
^
Radial play wear limit: 0.08 mm