S4 V8-4.2L (BHF) (2004)
Compressor Clutch Hub: Service and Repair
Drive Plate With Overload Protection, Removing and Installing
Drive Plate With Overload Protection, Removing And Installing
-
Remove compressor.
Removing
-
Remove bolts - A -.
NOTE: Use commercially available band wrench (with webbed band) to provide support at drive plate - C -.
Installing
-
Install drive plate with overload safeguard - B - to drive plate - C -.
-
Insert and hand-tighten bolts - A -.
-
Check run-out of drive plate - B -.
-
Tighten bolts - A - (tightening torque 10 Nm).
-
Check run-out of drive plate - B - again.