S4 V8-4.2L (BHF) (2004)
/Page-2233003.png)
5. Update the Engine Control Module (J623) using SVM action code as listed in the table below if necessary.
NOTE: Only VAS 6017B adapter can be used for this update. Usage of VAS 6017 or 6017A may result in complete control module failure.
-
If the vehicle has a tuned ECM or TCM, ensure the Control Module Tuning form has been filled out by the owner.
Tip: The SVM Process must be completed in its entirety so the database receives the update confirmation response. A warranty claim may not
be reimbursed if there is no confirmation response to support the claim.
-
After updating the programming of the ECM, it is not necessary to set the Readiness Code.
For further SVM update instructions and troubleshooting, please refer to the SVM Operating Manual; ElsaWeb TSB 2011732.
Warranty
When procedure applies to vehicles under warranty, use the table.
Required Parts and Tools
-
Approved charger.
Additional Information
The following Technical Service Bulletin will be necessary to complete this procedure:
