S4 V8-4.2L (BHF) (2004)
-
Remove accelerator pedal module -arrow-.
Installing
Installation is in reverse order of removal, note the following:
-
Install left knee bolster:
-
Kick down function must be adapted when replacing accelerator pedal module: To do so, switch on ignition and press accelerator pedal all the way
down past the kickdown point and hold in position for at least 20 seconds.
-
Switch ignition off.
-
Engine Control Module (ECM) now requires approx. 3 seconds to store the learned value. At this time, the ignition must not be switched on
again
Tightening torque
Component
Nm
Accelerator pedal module at pedal mount
9