S4 V8-4.2L (BHF) (2004)
-
Camshaft Position (CMP) Sensor 2 -G40- (bank 1)
Harness connector Terminal
Test box Socket
1 (B+)
98
2 (signal)
87
3 Ground (GND)
108
-
Camshaft Position (CMP) Sensor 2 -G163- (bank 2
Harness connector Terminal
Test box Socket
1 (B+)
98
2 (signal)
86
3 Ground (GND)
108
Specified value: Wire resistance max 1.5 Ohms.
-
Check wires for short circuit to each other as well as to B+ and Ground (GND).
-
Specified value: Infinite Ohms. (no continuity)
-
If necessary, repair wire connection.
Assembly is performed in the reverse order of removal, note the following:
-
Check coolant level.
Final procedures
After repair work, the following work steps must be performed in the mentioned sequence:
1. Check DTC memory see "Mode 3: Check DTC memory". See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Scan Tool Testing and Procedures/Mode 3: Check DTC Memory
2. If necessary, erase DTC memory see "Mode 4: Reset/erase diagnostic data". See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Mode 4: Reset/Erase Diagnostic Data
3. Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles
and Readiness Codes/Readiness Code, Generating
-
End diagnosis and switch ignition off.