S4 V8-4.2L (BHF) (2004)
1
-
Front airbag crash sensor
-
Removal:
-
Disconnect battery Ground (GND) strap.
-
Depending on engine version, remove air duct if necessary.
-
Disengage tab on yellow connector - 3 - and disconnect connector.
-
Remove two bolts - 2 - on crash sensor - 1 -.
-
Installing:
Installation is reverse of removal. Observe the following when doing so:
-
Switch on ignition.
CAUTION: No one should be in vehicle when connecting battery.
-
Connect the battery ground (GND) strap.
NOTE:
-
Follow safety measures after connecting battery.
-
If the Airbag Malfunction Indicator Lamp (MIL) K75 shows a malfunction after assembly, DTC memory must be checked with Vehicle
Diagnostic, Testing and Information System VAS 5051 A, cleared and then rechecked.
2
-
Screws, (2x)
-
Tightening torque 9 Nm
3
-
Connector
4
-
Lock carrier