S4 V8-4.2L (BHF) (2004)
-
Remove seat pan cover and padding:
-
1.1. Seating area (standard seat) cover and upholstery, removing and installing
-
1.2. Seat pan cover and upholstery (sport seat), removing and installing
-
2.1. Seat pan cover and upholstery (standard seat), removing and installing
-
2.2. Seat pan cover and upholstery (sport seat), removing and installing
-
3.1. Seat pan cover and padding, removing and installing
NOTE: Remove padding only until Front Passengers Seat Occupied Sensor G128 - 2 - has been freed up.
-
Remove Front Passengers Seat Occupied Sensor G128 connector - 2 -.
-
Carefully remove Front Passengers Seat Occupied Sensor G128 - 2 - from seat padding - 1 -.
-
Installing
CAUTION: Observe safety precautions for work on airbags.
Installation is reverse of removal. Observe the following when doing so:
-
Position circuit board - 4 - from Front Passengers Seat Occupied Sensor G128 - 2 - in cut-out - 3 - in seat padding - 1 -.
-
Align Front Passengers Seat Occupied Sensor G128 - 2 - on seat padding - 1 - as shown in illustration.
-
Remove protective foil and adhere Front Passengers Seat Occupied Sensor G128 - 2 - to seat padding - 1 -.