S4 V8-4.2L (BHF) (2004)
Wiring Harness: Service and Repair
Notes on Repairs on Wiring Harnesses and Connectors
Notes On Repairs On Wiring Harnesses And Connectors
CAUTION:
-
Do not solder components of the vehicle electrical system.
-
Do not perform repairs on heat-shrink sleeves. Route a new wire along the faulty wire if necessary.
-
Shielded wires, e.g. on speed sensor and knock sensors, are NOT to be repaired. These wires must be replaced complete if damaged.
-
Only use yellow wires for repairs to wiring. Mark location of repair with yellow insulating tape.
-
Yellow wiring and locations with yellow insulating tape on wiring harness designate a previous repair.