S4 V8-4.2L (BHF) (2004)
^
Installation position: open side of seal faces cover.
-
Insert pressure application device T10136/1 with seal into cover from above.
Note:
^
The peg of the pressure application device T10136 serves as a guide from below and also as a stop for press tool T10136/1.
-
Drive new seal in onto stop (take care to keep seal straight).
-
Pack space between sealing lip and dust lip half full with sealing grease G 052 128 A1.
-
Press flange shaft using punch VW 409 and thrust pad VW 4471 into Torsen differential cover by placing cover on thrust plate VW 401 and thrust
plate VW 402.
Note:
^
Only insert flange shaft as far as necessary to install circlip.