S4 V8-4.2L (BHF) (2004)
^
Make sure that pin is not pressed out completely.
-
Pull selector lever cable - 4 - out of selector mechanism.
Note:
^
Do not bend or kink the selector lever cable.
Installing
Installation is performed in reverse sequence. Note the following:
-
Install new retaining clip - 1 - for selector lever cable on selector mechanism.
^
Installation position: The angled end of the retaining clip faces to the inside of the selector mechanism.
-
Insert end of selector lever cable - 4 - in joint on selector lever.
-
Push pin - 3 - down - arrow -.
-
Check that plastic securing spring - 2 - has locked the pin.
-
Secure cover to underside of selector mechanism - arrows -.
-
Attach sleeve for selector lever cable to selector mechanism cover (bottom).
-
Shift selector lever from position "P" to "S"
^
Selector mechanism and selector lever cable must move freely. If necessary replace selector lever cable or service selector mechanism.
Note:
^
Do not bend or kink the selector lever cable.
-
Shift selector lever to position "P".
-
Push selector shaft lever - 2 - on transmission toward rear as far as possible (in illustration: as far as possible to the right) until parking lock
engages.