S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
Front Bumper Reinforcement: Service and Repair
Bumper Crossmember to Impact Absorber Mount
Bumper Crossmember To Impact Absorber Mount
NOTE:
-
Impact absorber is self-adjusting, meaning it can compensate bearing tolerances in height between crossmember and Impact absorber when
installing the bolt.
-
This holds and secures the crossmember automatically in the previously adjusted position when installing the bolt - 1 -.
1
-
Screw
-
23 Nm
2
-
Lower carrier bushing
-
Plastic part pressed into adjusting screw.
-
No replacement part.
3
-
Lower adjusting screw
-
Before assembling bumper crossmember, install completely but do not tighten.
-
Left-hand thread
-
No replacement part.
4
-
Lower threaded bushing
-
Secured against falling out with securing pin.
-
No replacement part.
5
-
Securing pin
-
No replacement part.
6
-
Impact absorber
-
Removing and installing
7
-
Upper threaded bushing