S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
/Page-1941002.png)
^
Do not disconnect brake hose when changing brake pads
^
Brake caliper, servicing
4 - Brake pads
^
Always replace both sides
^
Do not disconnect brake hose when changing brake pads
^
To change brake pads, only remove lower brake caliper bolt, item 2, and fold caliper up.
^
Checking brake pad thickness: 803
5 - Brake pad retaining spring
^
Always replace when changing pads
6 - Wheel bolts
^
Mount wheels.
7 - Torx bolt
^
Torque specification 5 Nm
8 - Brake disc
^
Always replace both sides
^
Remove brake caliper prior to removing
^
Coat contact surfaces between brake disc and wheel hub with Polycarbamide grease G 052 142 A2.
^
Ensure sufficient wear limit
9 - Hex socket heat screw, 75 Nm
^
M10×60
^
Always replace
10 - Brake carrier with guide pins and protective cap
^
Supplied as replacement part assembled with sufficient grease on guide pins
^
If protective caps or guide pins are damaged use repair kit. Use supplied grease packet to lubricate guide pins.
11 - Banjo bolt, 45 Nm
12 - Brake line with banjo fitting
^
Hose must be installed free of twists
^
To replace brake pads, unfasten from brake carrier
^
Do not disconnect brake hose when changing brake pads
^
Brake caliper, servicing
13 - Seals
