S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
-
Remove head-level airbag - 2 - from vehicle.
‹› Installing:
CAUTION!
Always follow side curtain airbag installation procedure.
-
Insert brackets - arrows -.
-
Secure four brackets - arrows - beginning from behind with four bolts - 4 -.
-
Install three bolts - 3 -.
-
Install last bolt - 5 -.
-
Install four bolts - 7 -.
-
Install bolt - 6 -.
-
When connecting harness connector - 1 -, make sure that it is firmly engaged.
Further installation is performed in the reverse order of removal. Observe the following when doing so:
-
Switch on ignition.
CAUTION!
No one should be in vehicle when connecting battery.
-
Connect the battery ground (GND) strap.
‹› Follow safety measures after connecting battery.
‹› If the Airbag Malfunction Indicator Lamp (MIL) ( K75) shows a malfunction after assembly, DTC memory must be checked with Vehicle
Diagnostic, Testing and Information System ( VAS 5051 A), cleared and then rechecked.
3
Bolts (Qty. 3)
‹› Tightening specification 3.5 Nm
‹› Self-locking
‹› Replace after each disassembly
‹› Threaded holes for screws must always be cleaned (for example, with thread cutter)
4
Screws (Qty. 4)
‹› Tightening specification 3.5 Nm
‹› Self-locking
‹› Replace after each disassembly
‹› Threaded holes for screws must always be cleaned (for example, with thread cutter)
5
Bolt
‹› Tightening specification 3.5 Nm
‹› Self-locking
‹› Replace after each disassembly
‹› Threaded holes for screws must always be cleaned (for example, with thread cutter)