S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
Backup Lamp Switch: Service and Repair
0A3A Transmission
Back-Up Light Switch, Removing
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1331)
Removing
-
If equipped, loosen quick-release connectors - 3 - and remove rear noise insulation - B -.
-
Disconnect connector - arrow - on the Back-Up Light Switch (F4) to the transmission on the right side.
-
Remove the Back-Up Light Switch (F4) - arrow - from the selector shaft cover.
Installing
-
Install the Back-Up Light Switch (F4) - arrow - in the selector shaft cover and tighten it to 20 Nm.