S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
-
Slide fiber optic cable - 2 - into brass pin contact - 1 - as far as spring-loaded stop.
-
Slide fiber-optic cable further in up to fixed stop and close Crimping Pliers For Fiber-optic Cable VAS 6223/2.
-
Open Crimping Pliers For Fiber-optic Cable and remove fiber-optic cable with brass pin contact.
CAUTION: Do not excessively bend or kink fiber optic cables. (min. bending radius 25 mm).
-
Check proper attachment of brass pin contact - 2 - to fiber optic cable - 1 -.
-
4 crimp points must be visible at brass connection pin.
-
The brass pin contact must not be able to be removed by hand from fiber-optic cable.
-
End face of fiber optic cable is located 0.01 to 0.1 mm behind brass pin contact (visual inspection).
NOTE:
-
Plug-in couplings are available for connecting fiber optic cables.
-
For installing new fiber optic cable in wiring harness connector.
Installing corrugated tube on fiber-optic cable
-
Cut corrugated tube to appropriate length.
-
Use air hose pliers VAS 6228 or a sharp knife for cutting.
-
The corrugated tube must not be cut through using a side cutter under any circumstances
-
The corrugated tube must be cut on the wave peak - arrow -, not in the wave trough.
-
Guide fiber-optic cable into Crimping Pliers For Fiber-optic Cable VAS 6223/10 as shown in illustration.
-
Position Crimping Pliers For Fiber-optic Cable at slot of corrugated tube.
-
Position Crimping Pliers For Fiber-optic Cable at slot of corrugated tube. By doing this, fiber-optic cable is fed in corrugated tube.