S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
-
Remove universal mounting VAG 1359/2 from engine and transmission jack VAG 1383 A and place a wooden block - arrow - on the lifting
column in its place.
-
Support the rear cross member with engine and transmission jack VAG 1383 A.
-
First unscrew bolts - 1 - and - 2 -, then bolts - 3 - and - 4 -.
-
Lower rear cross member slowly with engine and transmission jack VAG 1383 A until distance between rear cross member and body reaches
dimension - x -.
^
Dimension - x - = 60 mm
-
Remove heat shield - arrows - for drive shaft (left-side).
-
Unbolt drive shaft - 1 - from flange shaft and move clear to the front.
-
Remove bolt - arrow - and take out clutch slave cylinder from the rear.