S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
Replacing O-ring
-
Remove O-ring - arrow - using a small screwdriver.
-
Lubricate new O-ring with gear oil before installing.
Removing input shaft oil seal
A - Counter support, e.g. - Kukko 22/1 -
B - Internal puller 30 to 37 mm, e.g. - Kukko 21/5 -
Installing input shaft oil seal
-
Lightly lubricate outer circumference of seal with gear oil.
-
Press in oil seal for input shaft as far as it will go.
^
The open side of seal faces towards press tool VW 454.
-
Pack space between sealing lip and dust lip half-full with sealing grease G 052 128 A1.