S4 Quattro Cabriolet V8-4.2L (BHF) (2008)
/Page-1671002.png)
3 - Clamp
^
Always replace
4 - Circlip
^
Only present on certain versions
5 - Spring washer
^
Only present on certain versions
^
Installed location
6 - Spacer ring (plastic)
^
Only present on certain versions
^
Installed location
7 - Circlip
^
Always replace
^
Insert before mounting in ring groove (not visible with joint installed)
8 - Outer constant velocity joint
^
Replace only as a unit
^
Pressing off
^
Installing:
^
Drive joint onto shaft with a plastic hammer until circlip engages.
^
Greasing
^
When installing joint on profile shaft, profile shaft splines must be lightly coated with grease used in joint.
9 - Bolt
^
Always replace if removed
^
Loosen
^
Fastening
^
Torque specification
10 - Clamp
^
Different versions for protective joint boot in rubber or Hytrel
^
Replace
11 - Outer constant velocity protective joint boot
^
Check for tears and chafing
^
Before clamping hose clamps, raise protective joint boot briefly to balance pressure
12 - Clamp
^
Replace
13 - Axle shaft
14 - Circlip
