S4 Quattro Wagon V8-4.2L (BHF) (2008)
Rear Bumper Cover / Fascia: Description and Operation
Rear Bumper Side Impact Molding Centering Holes, Avant
Rear Bumper Side Impact Molding Centering Holes, Avant
Up to Vehicle Identification Number (VIN) 400 000
‹› Centering holes for side impact molding must be drilled on a new bumper before painting.
1 - Rear bumper
‹› Markings for centering holes are positioned on the inside of the cover - arrows - as shown.
‹› Drill through cover at these locations (3x) using a drill bit dia. 8.5 mm before painting.
Adhering centering pins on side impact molding