S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-3400002.png)
Installing support piece
NOTE: Support piece must be installed only with a new bumper cover.
-
To remove, press catch - arrow - to the side and pull support piece downward out of cover - 1 -.
-
Insert support piece - 2 - into cover as shown and let engage inside.
-
Disengaging cord must be removed only when the cover is installed completely.
Disengaging support piece
CAUTION: Never disengage support piece in the removed condition - danger of injury.
-
When re-installing the old bumper cover, the old support piece remains installed.
-
When replacing the bumper cover, a new support piece must be clipped into the bumper cover from below.
-
After completely installing bumper cover, disengage support piece by pulling on disengaging cord - arrow -.
NOTE: By pulling disengaging cord, tension is released from support piece and reinforces the bumper cover against the crossmember.
