S4 Quattro Wagon V8-4.2L (BHF) (2008)
-
Raise door trim - 1 - upward approx. 20 cm out from door shell.
-
Disengage Bowden cable for interior door mechanism.
-
Disconnect electrical harness connectors.
-
Remove rear door trim.
‹› Installing:
Tightening Specifications
‹› 1.5 Nm
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
When installing, speed nuts - 8 - (Qty. 4) for expanding nuts - 7 - (Qty. 4) must be clipped in.
When installing, door trim must be pressed in center toward door shell.
When installing manual window crank, note its position.
2
Trim Panel
3
Bolt (Qty. 3)
4
Cover
5
Window Crank
6
Bolt
7
Expanding Nut (Qty. 4)
8
Spring Nut (Qty. 4)
9
Window Regulator Switch
Release, Disengaging
-
Remove circlip - 3 -.
-
Pull release - 1 - out of guide - 2 - and disengage.
‹› When installing make sure that catch - 3 - faces upward.
Connector On Window Regulator Control Module