S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-3703002.png)
‹› Removal:
-
Fold rear seat backrest down.
With fixed rear seat backrest:
-
Remove rear seat backrest. Refer to => [ Rear Seat Backrest, Fixed ] See: Seats/Service and Repair/Removal and Replacement/Rear Seats.
-
Remove D-pillar trim on left and right. Refer to => [ D-Pillar Trim ] See: D-Pillar Trim.
-
Remove left and right rear side bolsters. Refer to => [ Rear Seat Side Upholstery ] See: Seats/Service and Repair/Removal and Replacement/Rear
Seats.
-
Disconnect harness connector to 3rd brake light.
With fixed rear seat backrest:
-
Loosen third belt downward and thread it through.
‹› In the following, removal is described in three versions, depending on whether a rear shelf without fixtures, with speakers or with speakers and sun
shade is to be removed. The following steps beneath "All" are again valid for all three variations.
Version 1 Removal: Parcel Shelf without Fixtures
-
Proceed with removal as described under "All".
Version 2 Removal: Parcel Shelf with Integrated Speaker
-
Detach speaker grill - 3 - from rear shelf - 1 -.
-
Remove four bolts - 5 - between speakers and rear shelf - 1 -.
Version 3 Removal: Parcel Shelf with Integrated Speaker and Sun Shade
-
Detach speaker grill - 3 - from rear shelf - 1 -.
-
Remove two bolts - 5 - at front corners of speakers and one bolt - 5 - from below.
-
Remove three bolts of sun shade - 4 - in luggage compartment (from below). Refer to => [ Electrical Sun Shade Threaded Connection in Luggage
Compartment ]
-
Remove sun shade - 4 - toward front.
All:
-
Move rear shelf - 1 - toward front in direction of arrow and disengage it from insertion edge - 2 -.
-
Remove rear shelf - 1 - upward and toward front.
‹› Installing:
Depending on the version, installation is the reverse of removal.
2
Parcel Shelf Insertion Edge
3
Speaker (Grille)
4
Sun Shade
5
Bolts between Speaker and Rear Shelf
‹› Depending on version, 3 or 4 bolts in varying positions
Electrical Sun Shade Threaded Connection in Luggage Compartment
