S4 Quattro Wagon V8-4.2L (BHF) (2008)
Convertible Top Latch: Adjustments
Convertible Top Lock, Checking and Adjusting
‹› Front rail trim and cowl panel trim removed.
‹› Close convertible top.
-
Check position of convertible top lock and anchor plate to one another.
Convertible top lock pins - 1 - must not contact anchor plate - 2 -.
-
If necessary, adjust position of anchor plate - 2 -.
-
Loosen wire bracket retainers and press both push rods - 3 - off ball studs.
-
Check whether convertible top locks have reached their end position by pressing firmly on ball studs - 4 - in closing direction.
The push rods - 3 - must be able to be placed on the ball studs - 4 - in this position.
Convertible top locks and linkages, adjusting
‹› Push rods - 3 - removed from ball studs - 4 - on both sides.
-
Loosen Convertible Top Locking Motor (V223) bolts approximately one turn.
-
On right side of vehicle, place push rod - 3 - on ball stud - 4 -.
-
Tighten Convertible Top Locking Motor (V223) bolts.
-
Loosen lock nut - 5 - on left side of vehicle and adjust ball stud by screwing threads in or out.
-
Adjust ball stud - 3 - so that it can be placed on ball stud - 4 -.
-
Tighten lock nut in this position.
Tightening torques => [ Attachments Assembly Overview ] See: Service and Repair/Removal and Replacement/Attachments Assembly
Overview.