S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-887001.png)
Timing Cover: Service and Repair
Timing Chain Covers
Timing Chain Covers
Special tools, testers and auxiliary items required
‹› Old oil collecting and extracting device (V.A.G 1782 )
‹› Hand drill with plastic brush attachment
‹› Protective eyewear
‹› Sealant
Removing
‹› All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
-
Place old oil collecting and extracting device ( V.A.G 1782) under engine and drain engine oil.
-
Remove engine. Refer to: Vehicles with manual transmission => [ Engine, Manual Transmission, Removing ] See: Service and Repair/Removal
and Replacement/Engine, Manual Transmission, Removing, vehicles with automatic transmission => [ Engine, Removing ] See: Service and
Repair/Removal and Replacement/Engine, Automatic Transmission, Removing and Installing.
-
Disconnect engine and transmission. Refer to: Vehicles with manual transmission => [ Engine and Transmission, Separating ] See: Service and
Repair/Removal and Replacement/Engine, Manual Transmission, Removing, vehicles with automatic transmission => [ Engine and Transmission,
Separating ] See: Service and Repair/Removal and Replacement/Engine, Automatic Transmission, Removing and Installing.
-
Leave the engine on the Scissor Lift Table (VAS 6131 A) or secure the engine to the engine and transmission holder. Refer to: Vehicles with
manual transmission => [ Engine, Securing to Engine and Transmission Holder ] See: Service and Repair/Removal and Replacement/Engine,
Manual Transmission, Removing, vehicles with automatic transmission => [ Engine, Securing to Engine and Transmission Holder ] See: Service
and Repair/Removal and Replacement/Engine, Automatic Transmission, Removing and Installing.
-
Remove dual-mass flywheel. Refer to => [ Dual Mass Flywheel ] See: Transmission and Drivetrain/Flywheel/Service and Repair/Dual Mass
Flywheel, drive plate => [ Drive Plate ] See: Transmission and Drivetrain/Flex Plate/Service and Repair/Drive Plate.
-
Disconnect electrical connection - 1 - at throttle valve control module (J338).
-
Disconnect crankcase ventilation hose - 3 - at intake pipe.
‹› Ignore - 2 -.
-
Remove electrical harness connectors - 1 -, - 2 -, - 5 - and - 6 - toward front from brackets on intake pipe.
