audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Test Step 1|Page 8502 > < Test Step 1|Page 8500
Page 1
background image

Control Module HVAC: Component Tests and General Diagnostics
Climatronic Control Module A/C Control Head Electrical Component Testing

Climatronic Control Module A/C Control Head Electrical Component Testing

=> [ Heated Rear Window, Testing ] 

=> [ Heated Seats, Checking ] 

=> [ Heated Windshield, Checking Activation ] 

Heated Rear Window, Testing

‹› If there is a condition which does not allow activation of rear window heating (short circuit in the connection to the rear window or to the rear

window defogger relay (J9), open circuit in the voltage supply to the Climatronic control module (J255) A/C control head, or an open Cabrio
convertible top), the indicator lamp in the button illuminates when the button in the Climatronic control module (J255) A/C control head is pressed
and goes back out when released again but the heater is not activated

‹› If the voltage measured by the Climatronic control module (J255) A/C control head at terminal "30" is less than 12.5 V, the heated rear window

output is reduced and the load on the generator is relieved (the electronics of the Climatronic control module (J255) A/C control head reduces the
duty cycle of the activation from 100% to 90....10%).

‹› In the case of vehicles up to VIN "399999" of model year 2005 (in the Sedan and Avant) and "012912" of model year 2005 (Cabrio), the heated

rear window ( Z1) is directly controlled by the Climatronic control module (J255) A/C control head (the relay that connects the current is installed
in the Climatronic control module (J255) A/C control head)

‹› In the case of vehicles up to VIN "400000" of model year 2005 (in the Sedan and Avant) and "012913" of model year 2005 (Cabrio), the heated

rear window ( Z1) is no longer directly controlled by the Climatronic control module (J255) A/C control head (a relay is not installed in the
Climatronic control module (J255) A/C control head with a part number from index "AJ"). In these vehicles the heated rear window (Z1) is
controlled via the rear window defogger relay (J9).

‹› The heated rear window stays switched on at outside temperatures up to 0°C until ignition is switched off (heated rear window can be switched

manually at anytime). If the temperature becomes greater than 0°C during a driving period, switch-off of the heated rear window ( Z1) occurs after
the operating time stored in the Climatronic control module (J255) A/C control head has elapsed (approximately 12 minutes).

‹› Activation of the heated rear window (Z1) is automatically switched off at ambient temperatures greater than 0°C after expiration of the operating

time (approx. 12 minutes) stored in the Climatronic control module (J255) A/C control head by the Climatronic control module (J255) A/C control
head. 

‹› Vehicle Diagnosis, Testing and Information System ( VAS 5051A) (with inductive pickup 50 A (VAS 5051/9 ))

‹› Connector test set (V.A.G 1594C)

‹› All fuses OK 

-

Switch the ignition off.

-

Remove the Climatronic control module (J255) A/C control head.

-

Pull connectors - D - and - F - out of the Climatronic control module (J255) A/C control head.

Test Step 1|Page 8502 > < Test Step 1|Page 8500