S4 Quattro Wagon V8-4.2L (BHF) (2008)
1
Passive Occupant Detection System Control Module -J706
Installing
-
Secure Seat Occupied Recognition Pressure Sensor -G452- - 4 -.
-
Secure the Seat Occupied Recognition Control Module -J706 with the bolts - 2 - (Qty. 2) to 2.5 Nm.
-
Connect connector - 6 -.
-
Upholster the seat pan, thereby all upholstery clips must be attached and be installed at the original position. Refer to => [ Front Seat Covers and
Upholstery ] See: Body and Frame/Seats/Service and Repair/Overhaul/Seats - Upholstery, Covers/Front Seat Covers and Upholstery, for electric
seat => [ Front Seat Covers and Cushion, Power Memory Seats ] See: Body and Frame/Seats/Service and Repair/Overhaul/Seats - Upholstery,
Covers/Front Seat Covers and Cushion, Power Memory Seats.
Further installation is performed in the reverse order of removal.
-
After installing the passenger seat in the vehicle, the following program must be performed under "Airbag" in Guided Fault Finding.
When installing a new service kit and after every repair on the front passenger seat:
‹› -J706 Passive occupant detection system control module basic setting
2
Bolts
‹› 2.5 Nm
3
Connector on Seat Occupied Recognition Control Module -J706