S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-2143001.png)
Multiple Junction Connector: Service and Repair
Right Connector Station, Removing And Installing
Right Connector Station, Removing And Installing
Removing
-
Location: Right connector station - arrow - is located in right footwell beneath A-pillar trim.
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Remove A-pillar trim:
-
Press retaining clip and detach connector point from A-pillar - arrow -.
-
Unclip fuse panel at connector point.
-
Remove relays or control modules and then unclip appropriate relay carrier.
NOTE: Refer to the applicable wiring diagram for exact identification of connections on connector station Wiring Diagrams.
Installing
Install in reverse order of removal, noting the following:
-
Install A-pillar trim:
