S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-2247003.png)
-
Insert the yellow repair wire end from the front into the pliers jaws as far as the stop and squeeze the pliers together completely.
-
Open pliers again and remove the stripped wire end.
-
Repeat this procedure on the other repair wire end.
-
For the repair of a 0.25 mm 2 wire, use a small yellow crimp connector from the Wiring Harness Repair Set (VAS 1978A ).
-
To press the crimp connector, use the Crimping Pliers (Base Tool) (VAS 1978/1-2) from the Wiring Harness Repair Set (VAS 1978A) with the
Exchangeable Head, 0.35 mm-2.5 mm (VAS 1978/1-1).
-
Slide the small yellow crimp connector onto the vehicle-specific single wire at one side and onto the repair wire at the other side.
-
Crimp the crimp connection at both wire ends using crimp pliers.
