S4 Quattro Wagon V8-4.2L (BHF) (2008)
Clutch Switch: Service and Repair
6 SPD. M/T 0A3 AWD
Clutch Pedal Switch F36, removing and installing - 6 Spd. Manual Transmission 0A3 All Wheel Drive
Note:
^
Clutch Pedal Switch F36 may only be installed once so as to ensure a firm fit.
Removing
-
Remove storage compartment on drivers side.
-
Disconnect electrical connector - 1 - on clutch pedal switch.
^
The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod - arrow - of the Clutch Pedal Switch F36 should then rest
against the clutch pedal.
-
Release Clutch Pedal Switch F36 - 2 - by turning 45 degrees counterclockwise and take out of guide.
Installing
Installation is performed in reverse of removal; note the following:
-
Pull out operating rod - arrow - all the way before installing Clutch Pedal Switch F36.