S4 Quattro Wagon V8-4.2L (BHF) (2008)
-
Remove hex bolt - 1 -.
-
Remove guide link.
Installing
‹› Bonded rubber bushings have a limited torsional range. Only tighten threaded connections at control arms if vehicle is in curb weight position.
Refer to => [ Wheel Bearing, Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures/Front Suspension/Wheel
Bearing, Lifting to Curb Weight Position.
-
Tighten nut on joint pin.
-
Tighten hex bolt - 2 -.
-
Tighten hex bolt - 3 -.
-
Install tunnel crossmember and tighten the screws, where applicable. Refer to => [ Tunnel Crossmember ] See: Cross-Member/Front
Cross-Member/Service and Repair.
-
Install brake caliper, if necessary.
-
Mount wheel and tighten.