S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-2731003.png)
-
Remove backing plate.
-
Loosen nut - 1 -, remove hex bolt and lift out both control arms - 2 - upward.
The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
-
Swing wheel bearing housing in direction of arrow away to side, when doing this remove drive axle pin from wheel hub.
-
Secure drive axle to body, e.g. with wire.
-
Remove countersunk bolts - 1 -.
