S4 Quattro Wagon V8-4.2L (BHF) (2008)
Pressure Regulating Solenoid: Testing and Inspection
09L, 6 Speed A/T AWD
Pressure Regulator Valves, Checking
NOTE: The Automatic Transmission Pressure Regulating Valve 1 N215 , Automatic Transmission Pressure Regulating Valve 2 N216 , Automatic
Transmission Pressure Regulating Valve 3 N217 , Automatic Transmission Pressure Regulating Valve 4 N218 , Automatic Transmission Pressure
Regulating Valve 5 N233 , and the Automatic Transmission Pressure Regulating Valve 6 N371 are components of the Mechatronic unit in the
transmission.
Requirements
-
The battery voltage must be at least 12.5 Volts.
-
All electrical consumers must be switched off.
-
The parking brake must be engaged.
-
The elector lever must be in the "P" position.
-
The Ground (GND) connections to transmission must be OK.
Test sequence
-
Disconnect the electrical connector in the - direction of the arrow - and remove it from the Transmission Control Module (TCM) J217.
-
Observe safety precautions.
-
Check the electrical harness connector for contact corrosion and ingress of water.
If the electrical harness connector is not OK:
-
Repair the malfunction.
If the electrical harness connector is OK:
-
Check the wiring according to the wiring diagram:
If no malfunctions are found in the wiring:
-
Replace the Mechatronic unit in the transmission:
NOTE: The Automatic Transmission Pressure Regulating Valve 1 N215 , Automatic Transmission Pressure Regulating Valve 2 N216 ,
Automatic Transmission Pressure Regulating Valve 3 N217 , Automatic Transmission Pressure Regulating Valve 4 N218 , Automatic
Transmission Pressure Regulating Valve 5 N233 , and the Automatic Transmission Pressure Regulating Valve 6 N371 are components of the
Mechatronic unit in the transmission and cannot be replaced separately.
Final procedures
1. Check the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 03 - Read DTC Memory
2. If necessary, erase DTC memory of the Transmission Control Module (TCM) J217. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/Diagnostic Mode 04 - Erase DTC Memory
3. Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles
and Readiness Codes