S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-1366002.png)
-
Remove bolts - arrows - on retaining bracket for left-side flange shaft.
-
Screw puller T10037 onto differential cover - arrow -.
-
Pull out left flange shaft using puller T10037 only until bearing on shaft is removed from transmission housing.
CAUTION!
If the shaft is not kept centered, the splines of the shaft will fall against the inner seal between the final drive and transmission housing. The
seal will be damaged and require replacement.
-
Pull left flange shaft - A - out of transmission making sure that the shaft remains centered in the opening on differential - arrow -.
Installing
Installation is performed in reverse sequence. Note the following:
-
Clean flange shaft.
