S4 Quattro Wagon V8-4.2L (BHF) (2008)
Shift Cable: Adjustments
Selector Lever Cable, Checking and Adjusting
Selector lever cable, checking and adjusting - 09L, 6 Speed AWD A/T
Special tools, testers and auxiliary items required
^
Socket and key T40031
Procedure
-
Remove selector mechanism cover Go To Selector mechanism cover, removing and installing See: Shifter A/T/Service and Repair/Removal and
Replacement/09L, 6 Speed AWD A/T/Selector Mechanism Cover, Removing and Installing.
-
Shift selector lever to position "S".
-
Insert socket and key T40031 through access hole in selector mechanism to loosen clamping bolt at rear of selector lever cable approx. 1 turn.
Note:
^
Only loosen clamping bolt 1 turn - do not remove.
^
Clamping bolt can only be accessed with selector lever in position "S".
^
The selector lever must remain in "S" position when clamping bolt is loosened; otherwise, adjustment will not be correct.
-
Carefully move selector lever slightly forward and backward, without shifting lever into a different selector lever position.
-
Pull selector lever once more to rear as far as possible into "S" position and release the selector lever.
Note:
^
Do not touch selector lever again during adjustment process.
-
Tighten clamping bolt in this position using socket and key T40031.
-
Install selector mechanism cover.
-
Check selector mechanism.