S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-1468010.png)
CAUTION!
Bolts are replaced after installing transmission and tightened to final tightening specification.
‹› Flex joint in front exhaust pipe must not be bent more than 10°, otherwise it may be damaged.
-
Disconnect exhaust system at double clamps - arrows -.
-
Place plunger of Engine/Transmission Jack (V.A.G 1383 A) with a block of wood inserted between - 1 - on lower crossmember.
-
Support lower crossmember using Engine/Transmission Jack (V.A.G 1383 A).
-
First remove bolts - 1 - and - 2 -, then bolts - 3 - and - 4 -.
-
Slowly lower crossmember using Engine/Transmission Jack (V.A.G 1383 A).
