S4 Quattro Wagon V8-4.2L (BHF) (2008)
Note:
^
Do not depress clutch pedal after removing slave cylinder. The slave cylinder would then be destroyed once pedal force exceeds approx. 300 N.
-
To remove hose/line assembly, use a screwdriver to Pry off clip - A - as far as the stop. Only then can the hose/line assembly be pulled out.
Installing
Installation is performed in reverse sequence; note the following:
Note:
^
Do not allow brake fluid to come into contact with the transmission. If necessary, clean the transmission housing.
^
If the clutch slave cylinder is inserted at an angle, there is a danger that the operating rod will be guided past the clutch release lever.
^
To facilitate assembly, engage 6th gear before fitting slave cylinder.
^
When installing, press in slave cylinder so that securing bolt can be installed easily.
^
Always replace securing bolt.
-
To connect line to clutch slave cylinder, press in retaining clip - A - as far as it will go.
-
Push line - B - into clutch slave cylinder until it engages audibly.
-
Before inserting slave cylinder in transmission housing, lubricate area - a - of sleeve with lithium grease G052150A2.
-
Lightly lubricate surface where operating rod and clutch release lever make contact with copper grease Z381351TE.