S4 Quattro Wagon V8-4.2L (BHF) (2008)
^
Replace
3 - Constant velocity (CV) joint boot
^
Check for tears and chafing
^
Before clamping hose clamp, raise protective joint boot briefly to balance pressure.
4 - Clamp
^
Replace
5 - Multi-point socket head bolt
6 - Triple roller joint housing
7 - Triple rotor star with rollers
^
Chamfer - arrow - faces splines drive axle splines
^
When installing triple roller star on profile shaft, profile shaft splines must be lightly coated with grease used in joint.
8 - Circlip
^
Replace
9 - O-ring
^
Replace
10 - Cover
^
Replace
11 - Clamp
^
For triple roller joint
^
Replace
12 - CV boot for triple roller joint
^
Check for tears and chafing
^
Before clamping hose clamp, raise protective joint boot briefly to balance pressure. Joint must be in center position.
13 - Axle shaft
14 - Circlip
^
Replace
^
Insert in shaft groove
15 - Outer constant velocity joint
^
Replace only as a unit
^
Installing: Drive onto shaft using plastic hammer until compressed circlip seats.
^
Greasing
^
When installing joint on profile shaft, profile shaft splines must be lightly coated with grease used in joint.