S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-1603002.png)
-
Remove circlip
-
Press inner CV joint off of drive axle with special tool shown in illustration.
-
Remove inner CV joint protective boot from drive axle.
Inner CV joint, installing
-
Apply sealant - hatched surface - to clean surface on inner side of protective joint boot cap. Sealant bead: unbroken, 2 to 3 mm dia. Skirt area
around inner holes - arrow -.
-
Use sealant D 454 300 A2 for this
-
Slide joint protective boot onto drive axle.
-
Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.
Protective boot and cap contact surfaces must be free of grease!
