S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-1605002.png)
-
Press CV joint off of drive axle.
-
Remove protective boot with cap.
Inner CV joint, installing
-
Apply sealant D 454 300 A2 - hatched surface - to clean surface on inner side of protective boot cover or cap, and. Sealant bead: unbroken, 2 to 3
mm dia., skirt area around inner holes - arrow -.
Protective boot and cap contact surfaces must be free of grease!
-
Slide new protective boot with cap onto drive axle.
-
Pack 85 g joint grease into boot.
-
Before installing joint or triple roller star, splines - A - must be lightly coated with grease used in joint.
