S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-1678003.png)
Installing
-
Always replace circlip for flange shaft.
-
Clamp flange shaft in vice, using jaw protectors. Use new circlip - A - to press old circlip out of groove in flange shaft.
-
Lightly oil outer circumference of new oil seal.
-
Drive new oil seal for flange shaft in to a depth of 5.65 ±0.15 mm below outer surface of cover, making sure you keep seal straight.
-
Pack space between sealing lip and dust lip half-full with sealing grease G 052 128 A1.
-
Drive flange shaft in with drift VW 295.
-
Fit drive shaft heat shield.
-
Bolt drive shaft to flange shaft.
-
Fill up oil in transmission and check oil level.
-
Install noise insulation.
Tightening torque
