S4 Quattro Wagon V8-4.2L (BHF) (2008)
-
Remove left front exhaust pipe and catalytic converter, if equipped.
-
Remove nut - 1 - and pull transmission shift lever - 2 - from selector shaft of transmission.
-
Carefully pry off the sealing ring using Pulling Hook (T20143/1) without damaging the selector shaft.
‹› Check the selector shaft for damage.
Installing
-
To prevent damage to the seal - C -, the installation of the seal and selector shaft must only be performed with the Assembly Sleeve (01E 311 120)
- A -.