S4 Quattro Wagon V8-4.2L (BHF) (2008)
/Page-1548002.png)
‹› To provide a better illustration, subframe is shown removed.
Installing
-
Align differential mount.
-
Use Assembly Tool (T40032) as shown in illustration and remove differential mount - arrow -.
‹› Installation device from front.
‹› Bearing outer race flush with sleeve on subframe.
-
Place rear crossmember on rear final drive and tighten combi-bolts
-
Fasten rear crossmember with subframe.
-
Fasten front transmission support to rear final drive
-
Install driveshaft to rear final drive.
-
Remove Engine/Transmission Jack (V.A.G 1383 A ).
