S4 Quattro Wagon V8-4.2L (BHF) (2008)
CAUTION!
Make sure that contact surface for shaft oil seal is not damaged on the drive pinion.
Installing
Installation is in reverse order of removal. Note the following:
-
Coat outer edge of gasket with axle oil.
-
Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1.
-
Drive in new seal to stop, without canting seal.
-
Heat flange/driveshaft to a maximum of 80 degree.
CAUTION!
Wear protective gloves
-
Drive on flange/driveshaft far enough until circlip can be installed.
-
Install circlip - arrow -.